centos7 网卡识别为eth0 eth1

Posted 2020-10-02 tdtdttdd

使网卡识别为 eth0  

方法一。安装系统是，net.ifnames=0 biosdevname=0

方法二。（没有测试）：

修改网卡配置文件中的 DEVICE= 参数的关于 eth0

[[email protected] ~]# cd /etc/sysconfig/network-scripts/
[[email protected] network-scripts]# vi ifcfg-eno16777728
TYPE=Ethernet
BOOTPROTO=dhcp
DEFROUTE=yes
PEERDNS=yes
PEERROUTES=yes
IPV4_FAILURE_FATAL=no
IPV6INIT=yes
IPV6_AUTOCONF=yes
IPV6_DEFROUTE=yes
IPV6_PEERDNS=yes
IPV6_PEERROUTES=yes
IPV6_FAILURE_FATAL=no
NAME=eno16777728
UUID=8a3eade8-005c-46df-81f2-6e2598457bac
#DEVICE=eno16777728
DEVICE=eth0
ONBOOT=yes

网卡配置文件名称改为 ifcfg-eth0

[[email protected] network-scripts]# mv ifcfg-eno16777728 ifcfg-eth0

因 CentOS7 采用 grub2 引导，还需要对 grub2 进行修改，编辑 /etc/default/grub 配置文件，在 GRUB_CMDLINE_LINUX 这个参数后面加入 net.ifnames=0 biosdevname=0

[[email protected] network-scripts]# vi /etc/default/grub
GRUB_TIMEOUT=5
GRUB_DISTRIBUTOR="$(sed ‘s, release .*$,,g‘ /etc/system-release)"
GRUB_DEFAULT=saved
GRUB_DISABLE_SUBMENU=true
GRUB_TERMINAL_OUTPUT="console"
GRUB_CMDLINE_LINUX="rd.lvm.lv=centos/root rd.lvm.lv=centos/swap rhgb quiet net.ifnames=0 biosdevname=0"
GRUB_DISABLE_RECOVERY="true"

用 grub2-mkconfig 命令重新生成GRUB配置并更新内核

[[email protected] network-scripts]# grub2-mkconfig -o /boot/grub2/grub.cfg
Generating grub configuration file ...
Found linux image: /boot/vmlinuz-3.10.0-327.el7.x86_64
Found initrd image: /boot/initramfs-3.10.0-327.el7.x86_64.img
Found linux image: /boot/vmlinuz-0-rescue-4dd6b54f74c94bff9e92c61d669fc195
Found initrd image: /boot/initramfs-0-rescue-4dd6b54f74c94bff9e92c61d669fc195.img
done

重启系统

reboot

重启完成之后 验证，ip addr 或者 ifconfig