Host Controller transport layer and AMPs
Posted cxchanpin
tags:
篇首语：本文由小常识网(cha138.com)小编为大家整理，主要介绍了Host Controller transport layer and AMPs相关的知识，希望对你有一定的参考价值。
The logical Host Controller Interface does not consider multiplexing/routing over the Host Controller Transport Layer(s). The Host designer must consider this in deciding which of the multiple controller configurations it will support. Each logical AMP HCI installation is particular to a single AMP Controller. The Host shall direct each HCI Command to a specific AMP, and be aware of the source of each HCI Event, and manage flow control separately for each HCI. The Host‘s Controller_ID concept used for AMP enumeration may assist with this.
The logical HCI definition does not consider the initial discovery of what AMPs are present in the system.
The upper layers discover the AMP capabilities. As seen by the AMP Manager, each local AMP has a Controller_ID that is used to route the data and commands to the correct AMP Controller. This identifier is not used in AMP HCI.
The separate logical HCIswithin a system may be on the same physical HCI transport, on separate physical HCI transports, or any combination. This may require a layer of multiplexing, which isnot defined within this AMP HCI logical specification.
The logical HCI is not affected by this topology. The logical HCI definition describes commands and events as seen by a single AMP.以上是关于Host Controller transport layer and AMPs的主要内容，如果未能解决你的问题，请参考以下文章
谁应该在 Swift 上将 DisposeBag 保留在 MVVM(+controller) 中
加载ubuntu的时候卡在‘SMBus Host Controller not enabled'错误
swift 使用segue从controller-presenter获取数据
Swift：在调用 applicationDidEnterBackground 时确定 Active View Controller