How to do NTG2.5 coding with SDConnect C4

Posted paulakeener

tags:

篇首语:本文由小常识网(cha138.com)小编为大家整理,主要介绍了How to do NTG2.5 coding with SDConnect C4相关的知识,希望对你有一定的参考价值。

I’m here to tell you

It’s possible to coding NTG2.5 on the benchand test a few things, using SD connect C4 etc.

What you need to do is connect NTG2.5 with your Star Diagnoses SDConnect C4, you need to connect KL30/KL31/CAN-H/CAN-L, you don’t need to connect the ignition pin because NTG2.5 doesn’t have KL15.

And, you need to attach a 120ohm resistor as a terminal between CAN-H and CAN-L, it’s a request of CAN BUS protocol. You can check this. Found it on a forum

技术图片
技术图片

Then, if your connection are all correct, you should use vediamo to code your NTG2.5, the CBF file is HU25.cbf, you can’t use Xentry/DAS because there is no ZGW on your bench, so the Xentry/DAS will never be connected with NTG2.5.

If you want to test rear view camera, you just need connect your camera to the NTG2.5, but you need supply +12V power to your camera manually.

技术图片

Manually trigger the rear view camera output via Vediamo:

Just press “Rev. Cam.” item like below image in the system setting page, the rear view camera will active if you power the camera up.

技术图片

On a side note: KL31 bridge

KL 31 just means the Negative Battery Terminal / Ground (I am from germany and the schematics here and in other countries say that Klemme 31 (short KL. 31) is the Minus Terminal of an Battery.

So just connect Pin 15 (A-Block of the Quadlock Connector) to 12V+ (KL. 30) and Pin 12 to the Ground/Negative Terminal of your power supply (KL.31). And now press the ON Button and pray it works (which works always for me  )

以上是关于How to do NTG2.5 coding with SDConnect C4的主要内容,如果未能解决你的问题,请参考以下文章

How to do presentation

How to use GITHUB to do source control

How to use GITHUB to do source control

How do I code well?

How do I duplicate a resource reference in code behind in WPF?

How do I add elements to a Scala List?