eshing wind/tidal turbine using Turbogrid

Posted code-saturne

tags:

篇首语:本文由小常识网(cha138.com)小编为大家整理,主要介绍了eshing wind/tidal turbine using Turbogrid相关的知识,希望对你有一定的参考价值。

 

 

1 meshing wind turbine using Turbogrid

Geo: solidworks Mesh: Turbogrid

Typically Features of wind turbine blades

  • highly twisted
  • no shroud.

So this cannot be meshed in TurboGrid.

  1. The best option is to use ICEM CFD Hexa to generate a grid for such blades.
  2. One way to overcome this is to split the blade near the tip, so that you put an artificial shroud.

This can then be mesh in TurboGrid. As for the tip section you can generate a mesh in ICEM CFD Hexa or tetra and use ggi‘s to connect the two meshes in CFX Pre.

Limits

the shroud must be defined near the tip of blade but in the wind turbine study we need a region between tip and shroud for this we cannot use turbogrid

  1. GGI option for shroud can be used and has been used by ppl to simulate wind turbines using turbo-grid meshing.
  2. For Blade Profile definition you just need the co-ordinates. i. e.

If you want to rotate a blade about x. axis, define the airfoils in X-Y planes and vary Z co-ordinate. I myself have done this and my blade was twisted as well.

  1. Cartesian co-ordinates are enough, no need to enter cylindrical co-ordinates.

Created: 2019-05-12 周日 05:59

Emacs 25.3.1 (Org mode 8.2.10)

Validate

以上是关于eshing wind/tidal turbine using Turbogrid的主要内容,如果未能解决你的问题,请参考以下文章

附7 turbine

Turbine聚合监控

使用Turbine对集群进行监控

Hystrix集群及集群监控turbine

turbine源码分析

006hystrix.stream信息聚合Turbine