组网 RIP配置实验

Posted 2022-12-13 阿呆攻防

RIP配置实验

• • 实验拓扑
  • 实验要求
  • 实验步骤
  • • 路由器的基本配置

实验拓扑

实验要求

（1）路由器的基本配置：设置路由接口IP地址

（2）根据以上拓扑划分出的三个网段，要求配置RIP路由使所有客户机都能通信，该如何实现？

---

实验步骤

路由器的基本配置

设置路由器接口IP地址

1. RouterA的基本配置

Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#no ip domain-look
Router(config)#int f0/0
Router(config-if)#ip address 192.168.1.1 255.255.255.0
Router(config-if)#no shutdown
Router(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
Router(config-if)#exit
Router(config)#int f1/0
Router(config-if)#ip address 172.1.1.1 255.255.255.0
Router(config-if)#no shut

2. RouterB的基本配置

Router>en
Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#no ip domain-look
Router(config)#int f0/0
Router(config-if)#ip address 172.2.2.1 255.255.255.0
Router(config-if)#no shut
Router(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
Router(config-if)#exit
Router(config)#int f1/0
Router(config-if)#ip address 192.168.1.2 255.255.255.0
Router(config-if)#no shut
Router(config-if)#
%LINK-5-CHANGED: Interface FastEthernet1/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet1/0, changed state to up

3. RIP路由配置

   RouterA的RIP路由配置

Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#router rip
Router(config-router)#version 2
Router(config-router)#network 172.1.1.0
Router(config-router)#network 192.168.1.0
Router(config-router)#end

RouterB的RIP路由配置

Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#router rip（进入路由配置模式）
Router(config-router)#network 172.2.2.0
Router(config-router)#network 192.168.1.0
Router(config-router)#end
Router#
%SYS-5-CONFIG_I: Configured from console by console

4. 查看配置

   在RouterA运行show ip route会显示路由配置信息

在RouterB运行show ip route会显示路由配置信息

5. 测试连通，如果互通就说明配置成功

   ip route 0.0.0.0 0.0.0.0 192.168.1.2
   

6. 删除路由协议

no router rip