Protel DXP自动布线时报错 Error : Pad U12-10 Appears to be unroutable. Violation against Rule - Clea

Posted

tags:

篇首语:本文由小常识网(cha138.com)小编为大家整理,主要介绍了Protel DXP自动布线时报错 Error : Pad U12-10 Appears to be unroutable. Violation against Rule - Clea相关的知识,希望对你有一定的参考价值。

Error : Pad U12-10 Appears to be unroutable. Violation against Rule - Clearance Clearance Constraint (Gap=0.254mm) (All),(All) Detected.
Error : Pad U12-14 Appears to be unroutable. Violation against Rule - Clearance Clearance Constraint (Gap=0.254mm) (All),(All) Detected.
Error : Pad U7-1 Appears to be unroutable. Violation against Rule - Clearance Clearance Constraint (Gap=0.254mm) (All),(All) Detected.
Error : Pad U6-17 Appears to be unroutable. Violation against Rule - Clearance Clearance Constraint (Gap=0.254mm) (All),(All) Detected.
Error : Pad U4-20 Appears to be unroutable. Violation against Rule - Clearance Clearance Constraint (Gap=0.254mm) (All),(All) Detected.
Error : Pad U4-18 Appears to be unroutable. Violation against Rule - Clearance Clearance Constraint (Gap=0.254mm) (All),(All) Detected.
Error : Pad U4-14 Appears to be unroutable. Violation against Rule - Clearance Clearance Constraint (Gap=0.254mm) (All),(All) Detected.
Error : Pad U3-13 Appears to be unroutable. Violation against Rule - Clearance Clearance Constraint (Gap=0.254mm) (All),(All) Detected.
Error : Pad U2-9 Appears to be unroutable. Violation
改小了最小布线宽度还是不行,改了SMDNeckDown也不行,到底应该怎么改规则?

这个错误提示是Clearance(间距,间隔)超出Rule限制,你把Clearance规则改小,就可以进行自动布线等工作了。
但是我认为间距规则的设置一般要尽量宽些。
尤其是有些特殊的信号线,可能要间距更大些
有些电源线,一般电流较大,走线宽度应该大些
参考技术A 应该改最小间距,上面已经提示的很明显了,是因为最小间距规则冲突导致的无法布线,当然还有最小线宽的问题,最小线宽最好选用最大不超过焊盘宽度的线宽为宜

以上是关于Protel DXP自动布线时报错 Error : Pad U12-10 Appears to be unroutable. Violation against Rule - Clea的主要内容,如果未能解决你的问题,请参考以下文章

protel 修改PCB图纸大小

DXP里面怎么自动布线?

Protel DXP 2004中的warning:off sheet at***是啥意思,怎么改?

谁有protel,Dxp 2004的教程或者是说明书也可以。

protel99 pcb 边框为啥要画到keepoutlayer (禁止布线层)?

Protel DXP 新建PCB库文件的方法