配置lvs nat模式下real server服务器端lvsrs脚本

Posted 2020-10-15

因为lvs nat模式下，只有入站方向的流量经过lvs服务器，出站流量直接由Real server服务器响应，所以Real Server服务器必须做相应的配置才能响应客户数据包，即修改Real server做负载均衡时回包的源地址要改为VIP，另外要修改Real server的arp响应策略，关闭arp响应功能。

#!/bin/bash

#description:start real server

VIP=192.168.12.200

./etc/rc.d/init.d/functions

case "$1" in

   start)

   echo " Start LVS of Real Server "

   /sbin/ifconfig lo:0 $VIP broadcast $VIP netmask 255.255.255.255 up

   echo "1" > /proc/sys/net/ipv4/conf/lo/arp_ignore

   echo "2" > /proc/sys/net/ipv4/conf/lo/arp_announce

   echo "1" > /proc/sys/net/ipv4/conf/all/arp_ignore

   echo "2" > /proc/sys/net/ipv4/conf/all/arp_announce

   ;;

   stop)

   /sbin/ifconfig lo:0 down

   echo "0" > /proc/sys/net/ipv4/conf/lo/arp_ignore

   echo "0" > /proc/sys/net/ipv4/conf/lo/arp_announce

   echo "0" > /proc/sys/net/ipv4/conf/all/arp_ignore

   echo "0" > /proc/sys/net/ipv4/conf/all/arp_announce

   ;;

   *)

   echo "Usage:$0 {start|stop}"

   exit 1

 esac

通过service lvsrs {start|stop}开启或关闭lvsrs

本文出自 “夜色” 博客，请务必保留此出处http://liuqun.blog.51cto.com/3544993/1983302