linux 常用命令

Posted 2020-09-13

1,linux 启动级别

Linux系统有7个运行级别(runlevel)
运行级别0：系统停机状态，系统默认运行级别不能设为0，否则不能正常启动
运行级别1：单用户工作状态，root权限，用于系统维护，禁止远程登陆
运行级别2：多用户状态(没有NFS)
运行级别3：完全的多用户状态(有NFS)，登陆后进入控制台命令行模式
运行级别4：系统未使用，保留
运行级别5：X11控制台，登陆后进入图形GUI模式
运行级别6：系统正常关闭并重启，默认运行级别不能设为6，否则不能正常启动

运行级别的原理：
1。在目录/etc/rc.d/init.d下有许多服务器脚本程序，一般称为服务(service)

[[email protected] init.d]# more /etc/inittab
# inittab is only used by upstart for the default runlevel.
#
# ADDING OTHER CONFIGURATION HERE WILL HAVE NO EFFECT ON YOUR SYSTEM.
#
# System initialization is started by /etc/init/rcS.conf
#
# Individual runlevels are started by /etc/init/rc.conf
#
# Ctrl-Alt-Delete is handled by /etc/init/control-alt-delete.conf
#
# Terminal gettys are handled by /etc/init/tty.conf and /etc/init/serial.conf,
# with configuration in /etc/sysconfig/init.
#
# For information on how to write upstart event handlers, or how
# upstart works, see init(5), init(8), and initctl(8).
#
# Default runlevel. The runlevels used are:
#   0 - halt (Do NOT set initdefault to this)
#   1 - Single user mode
#   2 - Multiuser, without NFS (The same as 3, if you do not have networking)
#   3 - Full multiuser mode
#   4 - unused
#   5 - X11
#   6 - reboot (Do NOT set initdefault to this)
#
id:3:initdefault:

 

其中 id:3:initdefault: 表示从文字界面启动，id:5:initdefault: 表示从图形界面启动