openWRT查看接口连接速度的命令

Posted 2023-03-23

参考技术A 进入shell后，输入ethtool eth0

eth0为你想查看的接口。

Settings for eth1:

        Supported ports: [ TP MII ]

        Supported link modes:  10baseT/Half 10baseT/Full

                                100baseT/Half 100baseT/Full

                                1000baseT/Half 1000baseT/Full

        Supported pause frame use: No

        Supports auto-negotiation: Yes

        Supported FEC modes: Not reported

        Advertised link modes:  10baseT/Half 10baseT/Full

                                100baseT/Half 100baseT/Full

                                1000baseT/Full

        Advertised pause frame use: Symmetric Receive-only

        Advertised auto-negotiation: Yes

        Advertised FEC modes: Not reported

        Link partner advertised link modes:  10baseT/Half 10baseT/Full

                                            100baseT/Half 100baseT/Full

                                            1000baseT/Full

        Link partner advertised pause frame use: Symmetric

        Link partner advertised auto-negotiation: Yes

        Link partner advertised FEC modes: Not reported

        Speed: 1000Mb/s      这里为你当前查看的接口连接速度

        Duplex: Full

        Port: MII

        PHYAD: 32

        Transceiver: internal

        Auto-negotiation: on

        Supports Wake-on: pumbg

        Wake-on: g

        Current message level: 0x00007fff (32767)

                              drv probe link timer ifdown ifup rx_err tx_err tx_queued intr tx_done rx_status pktdata hw wol

        Link detected: yes