/*
* Arduino Serial Bypass - use an Arduino as a dumb USB 2 Serial Converter
*
* This code makes the Arduino not interfere with pins 0 and 1
* which are connected to RX and TX on the FTDI chip. This allows
* the data coming from the FTDI USB 2 Serial chip to flow directly
* to another device. Since RX and TX are labeled from the Arduino's
* point of view, don't cross the wires, but plug the device's
* RX wire into the RX pin 0 and the TX wire into the TX pin 0.
*
* Because this is a direct hardware connection, high baud rates
* like 115200 are not a problem like they are with SoftwareSerial.
*
* Credit goes to "ihsan". His original website is down at the time
* of writing, but I found the text archived on:
* http://web.archive.org/web/20101027200300/http://students.sabanciuniv.edu/kehribar/?p=19
*/
void setup()
{
pinMode(0,INPUT);
pinMode(1,INPUT);
}
void loop()
{
}