c_cpp I2CSlaveμC

Posted 2021-05-14

// PIC16F877A Configuration Bit Settings
// 'C' source line config statements

#include <xc.h>
#include <pic16f877a.h>
#define _XTAL_FREQ 8000000

// #pragma config statements should precede project file includes.
// Use project enums instead of #define for ON and OFF.

// CONFIG
#pragma config FOSC = XT    // Oscillator Selection bits (XT oscillator)
#pragma config WDTE = OFF   // Watchdog Timer Enable bit (WDT disabled)
#pragma config PWRTE = OFF  // Power-up Timer Enable bit (PWRT disabled)
#pragma config BOREN = OFF  // Brown-out Reset Enable bit (BOR disabled)
#pragma config LVP = OFF    // Low-Voltage In-Circuit Serial Programming Enable bit
#pragma config CPD = OFF    // Data EEPROM Memory Code Protection bit
#pragma config WRT = OFF    // Flash Program Memory Write Enable bits
#pragma config CP = OFF     // Flash Program Memory Code Protection bit
short z;
void interrupt I2C_Slave_Read()
{
  if(SSPIF == 1)
  {
    SSPCONbits.CKP = 0;

    if ((SSPCONbits.SSPOV) || (SSPCONbits.WCOL))
    {
      z = SSPBUF; // Read the previous value to clear the buffer
      SSPCONbits.SSPOV = 0; // Clear the overflow flag
      SSPCONbits.WCOL = 0;  // Clear the collision bit
      SSPCONbits.CKP = 1;
    }

    if(!SSPSTATbits.D_nA && !SSPSTATbits.R_nW)
    {
      z = SSPBUF;
      while(!BF);
      PORTD = SSPBUF;
      SSPCONbits.CKP = 1;
    }
    else if(!SSPSTATbits.D_nA && SSPSTATbits.R_nW)
    {
      z = SSPBUF;
      BF = 0;
      SSPBUF = PORTB ;
      SSPCONbits.CKP = 1;
      while(SSPSTATbits.BF);
    }

    SSPIF = 0;
  }
}

void I2C_Slave_Init(short address)
{
  SSPSTAT = 0x80;
  SSPADD = address;
  SSPCON = 0x36;
  SSPCON2 = 0x01;
  TRISC3 = 1;   //Setting as input as given in datasheet
  TRISC4 = 1;   //Setting as input as given in datasheet
  GIE = 1;
  PEIE = 1;
  SSPIF = 0;
  SSPIE = 1;
}

void main()
{
  nRBPU = 0;            //Enables PORTB internal pull up resistors
  TRISB = 0xFF;         //PORTB as input
  TRISD = 0x00;         //PORTD as output
  PORTD = 0x00;         //All LEDs OFF
  I2C_Slave_Init(0x30); //Initialize as a I2C Slave with address 0x30
  while(1);
}